Digilent Genesys 2 - Kintex-7 FPGA Development Board

Description

Digilent Genesys 2 - Kintex-7 FPGA Development Board. Shipped with USPS Priority Mail.
I have opened it and plugged it in a few times but never used it otherwise. The vivado voucher must be activated within a year of purchase, I got the board in november 2020, so you have untill november 2021 to activate the voucher which i havent used. Its for the Design suite because the kintex 325 part on the board is not supported by the free version of vivado.
You can check the specs on digilent.com:
https://store.digilentinc.com/genesys-2-kintex-7-fpga-development-board/
Fully-populated 400-pin FMC HPC connector w/ ten GTX lanes
USB-UART Bridge
128x32 pixel OLED
16-bit VGA connector
Pmod connector
for XADC signals
Two four-lane DisplayPort connectors
HDMI Sink and HDMI Source
10/100/1000 Ethernet PHY
1GB 1800Mbps on-board DDR3
USB 2.0 Host/Device/OTG PHY
Dedicated USB port for JTAG programming and data transfers
Micro SD card connector
Audio codec w/ four 3.5mm jacks
Serial Flash
Five Pmod ports
USB HID Host for mice, keyboards and USB MSD Host for storage
On-board FPGA:
Xilinx Kintex-7™ FPGA (XC7K325T-2FFG900C)
50,950 logic slices, each with four 6-input LUTs and 8 flip-flops
16 Mbits of fast block RAM
Ten clock management tiles, each with a phase-locked loop (PLL)
840 DSP slices
Internal clock speeds exceeding 450MHz
On-chip analog-to-digital converter (XADC)
Up to 10.3125Gbps gigabit transceivers
1800Mbps DDR3 data rate with 32-bit data width
Commercial -2 speed grade