LPC2294 (ARM7) Board, 4x CAN, 128x128 TFT, Ethernet, USB, RS232

Description

LPC2294 (ARM7) Board, 4x CAN, 128x128 TFT, Ethernet, USB, RS232
LPC-E2294-8MB
LPC2294 ARM Development Board with USB, 4x CAN, RS232, Ethernet, USB, 128×128 TFT LCD and SD/MMC card connector. This board has 8MB external RAM and 2MB Flash Program Memory.
Note:
The picture on the right shows this board with a 2x16 character LCD. The version you order from this page comes with a 128x128 pixel color TFT LCD.
LPC2294 ARM Board Features
MCU: NXP LPC2294 16/32 bit ARM7TDMI-S with 256K Bytes Program Flash, 16K Bytes RAM, external memory bus, RTC, 4x 10 bit ADC with 2.44 uS conversion time, 2x UARTs, 4x CAN, I2C, SPI, 2x 32bit Timers, 7x CCR, 6x PWM, Watchdog Timer, 5V tolerant I/O and up to 60MHz operation
8MB (2 M x 32bit) 70ns K1S321611C External PSRAM
2MB (256Kx16bit) 70ns TE28F160C3BD70C3 External Intel Flash
2x10 pin ARM JTAG connector
for programming/debugging with
ARM JTAG In-Circuit Debuggers & Programmers
Optional TRACE connector (not assembled)
Nokia 6610 TFT 128x128 12-bit color LCD with backlight
SD/MMC card connector
USB to serial UART converter; board can be powered from USB bus.
Note:
The power supplied from the USB bus may be insufficient during programming of the board's Flash memory. It is recommended that you power the board with an external power supply during programming/in-circuit debugging.
RS232 driver and connector
Ethernet 100Mbit with DM9000E
4x CAN drivers and connectors
UEXT connector (see below)
RESET circuit with external control of Philips ISP utility via USB-RS232 virtual port
Jumpers for boot select from external memory
Jumpers for ISP/RUN mode
2 Push Buttons
Potentiometer connected to AIN0
I2C 24LC515 EEPROM on board
Two on-board voltage regulators 1.8V and 3.3V with up to 800mA current