Protoboard Project Prototyping Circuit Board Pre Drilled Through Hole Soldering

Description

Vector 3677-2 DIP Plugboard
Accepts Card Edge Connector
(Card Edge Connector Available
but not included)
Need the Card Edge Connector for this Board?
I sell those too.
Has Pre-Tinned Solder Pads for Quick
Easy Soldering
Holds up to Twelve 16 Pin DIP Packages
This is a quality made board. See the note
below that addresses the one reviewer's
unjustified complaint!
Electrical Engineers use this board a lot
for building prototypes and to test design
ideas. I worked in the electrical engineering
Test Lab of a Major OEM before I retired
and saw these used a lot. These boards
are preferred by experienced electrical
engineers to test and re-work their
designs. So they should be more than
capable of meeting your needs as well.
These boards are "New Old Stock" and some
are blue in color rather than the color shown.
If you have a preference, please send a
note and I will try to accommodate you, but
I can't promise that my remaining stock
will include your color of choice. If you
must have one color or the other, please
ask me for a stock check before buying
(I can often get back to you within 30
minutes).
Many boards have been removed from the
plastic packaging and are without the
layout paper; however, a layout paper can
be printed from the PDF File I have that
is available upon request.
Description:
4.5" X 6.5" X 0.062, Hole Dia.: 0.042"
3-Hole Solder Pads ( 0.28” x 0.080” )
Holes are not plated-thru.
Voltage/ground buses interleaved
between pad areas on wiring side.
Test point area with solder pads around
holes, provided along back edge of board.
Unclad test point area at top of board
Row and column legends provided.
Circuit Pattern :
3-Hole Solder Pad 1 side only
Contacts :
22/44 @ 0.156" Centers Ni / Gold
16 Pin DIP Capacity: 12
Hole Diameter :
0.042" { 1.0668 mm }
Grid :    0.100" X 0.100" { 2.54mm X 2.54mm }
Dimension { H, W, T } :
4.5" X 6.5" X 0.062"
Note:
I noticed that one reviewer gave this
product an unjustified 1-Star Rating
because the board does not have
plated-thru holes.
Plated-thru holes are only beneficial when
there are solder pads on the opposite side
of the board (which is not the case with
most prototyping boards, including this one).
Please don't let the unrealistic expectations
of inexperienced people mislead you.
Anyone who has worked in the field of
Electrical Engineering knows that Vector
Products are good quality, and used
everywhere by experienced electronics
professionals.
Sorry, No Local Pick-Ups